Microconnect B-FTP610Y Netwerkkabel geel 10 m Cat6 F/UTP (FTP)

The Microconnect B-FTP610Y is a 10 m Cat6 networking cable with F/UTP shielding and RJ-45 connectors on both ends. It supports Cat6 performance up to 250 MHz and data transfer rates up to 10000 Mbit/s, providing a stable connection between devices such as switches, modems, routers or to structured cabling through patch panels, keystone jacks or wall outlets. The cable's yellow jacket makes routing and identification simple, and the built-in latch protection reduces the risk of connector damage during installation in confined spaces.

Advantages

Shielding (F/UTP) reduces electromagnetic interference (EMI) and helps prevent crosstalk, maintaining signal integrity and lowering error rates. Backwards compatibility with Cat5e and Cat5 ensures interoperability with existing networks. The RJ-45 connectors and durable construction support reliable, high-speed data transmission and practical identification thanks to the yellow cable colour.

Suitable for

• Connecting switches, routers and modems to network infrastructure
• Patch panels and keystone jack terminations
• Small office and home network installations
• LAN gaming and multimedia streaming where reduced interference is needed

Key specifications

• Standard: Cat6 (tested up to 250 MHz)
• Shielding: F/UTP (foil shielded pairs with overall drain)
• Length: 10 m
• Connectors: RJ-45 to RJ-45
• Max data rate: up to 10000 Mbit/s (manufacturer specification)
• Colour: Yellow
• Weight: 0.166 kg

How to use

Plug one RJ-45 connector into the network device (switch, router or modem) and the other into the target device or wall outlet/patch panel. Ensure both connectors are fully inserted until the latch clicks to secure the connection. Route the cable to avoid tight bends and sources of strong electromagnetic noise for optimal performance. For professional terminations, verify compatibility with keystone jacks and patch panels designed for Cat6 cables.

Recommendations

For best results, keep cable runs within recommended length limits for Ethernet applications, avoid running this cable parallel and close to high-voltage power lines, and test links after installation to confirm signal quality and throughput.