Microconnect SSTP602PI netwerkkabel roze 2 m Cat6 S/FTP (S-STP)

The Microconnect SSTP602PI is a 2 m Cat6 networking cable with S/FTP (SSTP) shielding and RJ-45 connectors on both ends. It supports data transfer rates up to 10000 Mbit/s and is suitable for connecting switches, modems, routers or patch panels in home and small office networks. The cable is backwards compatible with Cat5e and Cat5 standards and is available in pink.

Advantages

This Cat6 cable is tested to the Cat6 standard (up to 250 MHz) and includes S/FTP shielding to reduce electromagnetic interference (EMI) and crosstalk, resulting in more stable data transmission and fewer errors. The connectors have latch protection to prevent damage during installation in confined spaces. The 2 m length provides flexibility for typical desk- and equipment-level connections while the RJ-45 terminations ensure compatibility with standard network ports.

Suitable for

• Connecting router to switch or modem
• Patch panel to network devices
• Small office and home network wiring
• High-speed Ethernet connections up to 10 Gbit/s over short distances

Key specifications

• Cable standard: Cat6 (tested up to 250 MHz)
• Shielding: S/FTP (SSTP) shielding
• Connector type: RJ-45 to RJ-45
• Length: 2 m
• Max data rate: up to 10000 Mbit/s
• Colour: Pink
• Compatibility: Backwards compatible with Cat5e and Cat5

How to use

Plug one RJ-45 connector into the network port of your device (router, switch, modem or wall outlet) and the other connector into the destination device or patch panel. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends or tight compression and keep it separated from high-power electrical cables where possible to maintain optimal signal quality.

Recommendations

For best performance, use this shielded Cat6 cable in environments where EMI or crosstalk may occur (near power supplies, fluorescent lighting, or dense cable bundles). Keep runs for 10 Gbit/s applications within recommended distances for Cat6 and avoid excessive bending or crushing of the cable.