Netwerk-transceivermodule CBO BlueOptics 49Y4218 SFP+ 10 Gbit/s 850 nm

CBO BlueOptics 49Y4218 SFP+ 10 Gbit/s 850 nm is a hot-pluggable network transceiver module designed for short-range multimode fiber links. It supports a 10 Gbit/s data rate over an 850 nm wavelength and is intended for use with compatible SFP+ ports in switches, servers and storage systems. The module simplifies deployment and maintenance in data center and enterprise network environments by offering a compact optical interface for high-speed uplinks and server connections.

Advantages

The module provides reliable 10 Gbit/s throughput on multimode fiber with an 850 nm VCSEL design suitable for short distances. Its hot-pluggable SFP+ form factor allows easy installation and replacement without system shutdown. The small, standardized footprint reduces space use in high-density equipment and supports interoperability with standard SFP+ ports from a wide range of networking devices.

Suitable for

• Short-range 10 Gbit/s links in data centers
• Server-to-switch uplinks on multimode fiber
• High-density switch ports requiring SFP+ optics
• Enterprise network aggregation and distribution layers

Key specifications

• Form factor: SFP+ (hot-pluggable)
• Data rate: 10 Gbit/s
• Wavelength: 850 nm
• Fiber type: Multimode fiber (MMF)
• Typical reach: short-range multimode links (OM3/OM4 or equivalent)
• Connector type: LC duplex

How to use

Insert the SFP+ module into a compatible SFP+ port on the switch, server or storage device until it seats securely. Connect LC duplex multimode fiber patch cables to the module using correct transmit/receive orientation. Ensure both ends of the fiber link are using compatible multimode specifications and that device interfaces are configured for 10 Gbit/s operation. Monitor link status via the host device management interface and replace the module by removing it while the system remains powered if hot-swap capability is supported.

Recommendations

Use OM3 or OM4 multimode fiber for reliable short-range 10 Gbit/s performance and keep fiber connectors clean to avoid signal loss. Verify compatibility with the host device’s SFP+ specifications before installation and consult device documentation for any required firmware or port settings.