Netwerkkabel LOGON TCR55SS250W Cat5e SF/UTP (S-FTP) wit 25 m RJ-45–RJ-45

LOGON TCR55SS250W Cat5e SF/UTP (S-FTP) White 25 m is a shielded Ethernet patch cable with RJ-45 connectors on both ends, designed for reliable data transmission in home, office and structured cabling environments. The cable uses four twisted pairs (4 x 2 AWG 26/7) with an overall foil and braided shield to reduce electromagnetic interference and maintain a stable 100 Ohm impedance. With a 25 m length and molded boots featuring kink protection and strain relief, this white CAT5e cable is suitable for linking network devices where improved shielding is required.

Advantages

The shielded construction (SF/UTP / S-FTP) combines foil and braid to limit crosstalk and external EMI, improving signal integrity compared to unshielded alternatives. RJ-45 shielded connectors ensure continuous grounding of the shield, and the molded boots with strain relief protect the connector from bending and mechanical stress. The cable meets Cat5e performance requirements for Ethernet applications and offers a convenient 25 m length for moderate-distance connections without additional patch points.

Suitable for

• Connecting switches, routers, patch panels and network interfaces within offices and homes
• Structured cabling runs where additional shielding is necessary to reduce interference
• Environments with nearby electrical equipment or cable bundles requiring EMI protection
• Temporary or permanent horizontal patching for Cat5e networks up to 25 m

Key specifications

• Cable category: Cat5e (SF/UTP, S-FTP)
• Length: 25 m
• Conductor configuration: 4 x 2 AWG 26/7 twisted pairs
• Characteristic impedance: 100 Ohm
• Connectors: RJ-45 male — shielded, both ends
• Shielding: foil + braid (overall) with individually twisted pairs
• Jacket colour: white
• Boot: molded with kink protection and strain relief

How to use

Connect one RJ-45 end to your network device (for example a router, switch or PC Ethernet port) and the other end to the corresponding port on the remote device or patch panel. Ensure both connector shields make contact with metal ports to preserve the shield continuity. Route the cable without sharp bends and avoid running it in parallel close to high-voltage power lines to minimise interference. For installation through conduits or cable trays, check that the bend radius is maintained and the length is suitable for the intended run.

Recommendations

For best performance, use LOGON TCR55SS250W in environments where foil/braid shielding provides tangible benefits — near industrial equipment, bundled with power cabling, or in dense cable installations. Verify connector shielding continuity with metal RJ-45 ports and avoid over-tightening cable ties; allow some slack to reduce mechanical stress on the strain relief.