Netwerkkabel ShiverPeaks 75717-H-SET10 Cat 6 S/FTP PIMF, 10-pack

ShiverPeaks 75717-H-SET10 Cat 6 S/FTP PIMF, 10‑pack is a set of ten category 6 network cables designed for structured cabling and gigabit Ethernet environments. Each cable combines individually foil‑shielded twisted pairs with an overall braided shield to lower alien crosstalk and electromagnetic interference. The set is intended for in‑building horizontal cabling, patch panel connections, switch links and office LAN installations where consistent signal integrity and predictable performance are required.

Advantages

The S/FTP PIMF construction provides pair‑by‑pair foil shielding plus an overall braided shield, improving resistance to external interference and reducing near‑end and far‑end crosstalk compared with unshielded alternatives. Delivered as a 10‑pack, the set simplifies procurement and deployment for multi‑port cabinets and workspace rollouts. The cables are designed to meet Category 6 electrical characteristics suitable for gigabit Ethernet and structured cabling standards, offering stable performance across typical office installation lengths.

Suitable for

• Connecting switches to patch panels in office LANs
• Horizontal in‑building cabling runs
• Workstation to wall‑port connections
• Environments with elevated electromagnetic interference or dense cabling

Key specifications

• Cable category: Cat 6 (suitable for gigabit Ethernet)
• Shielding: S/FTP — overall braid with individually foil‑shielded pairs
• Conductor construction: twisted pairs with PIMF (pair in metal foil) design
• Suitable use: structured cabling, patching, horizontal runs
• Pack quantity: 10 cables

How to use

Install the cables following standard structured cabling practices: measure run lengths to avoid excessive slack, route cables through trays or conduits to reduce bend and crush, and terminate connectors or patch panels according to T568A or T568B wiring schemes as required. Ensure the braided drain or shield is properly connected to grounding points at patch panels or outlet plates to maintain shielding effectiveness. Test each terminated cable with a certified cable tester to verify continuity, pair mapping and performance parameters before finalizing the installation.

Recommendations

For best results, avoid running S/FTP cables in direct parallel with high‑voltage power lines for long distances; maintain appropriate separation or use conduit where necessary. Use compatible shielded connectors and grounded patch panels to preserve shielding performance. Periodic testing after installation ensures sustained gigabit throughput and helps identify any degradation from physical damage or improper termination.