Netwerkkabel ShiverPeaks 75900-100HSSP S/CONN Cat 6 100,0 m

The ShiverPeaks 75900-100HSSP S/CONN Cat 6 100.0m is a halogen-free network cable engineered for reliable Gigabit Ethernet and high-bandwidth applications. Constructed with S/FTP shielding and a PIMF (Pairs in Metal Foil) arrangement, the cable reduces crosstalk and external electromagnetic interference to maintain stable data transmission over a 100 metre length. The cable's design supports standard Cat 6 performance requirements and is suitable for structured cabling in homes, offices, and small data environments.

Advantages

This network cable combines S/FTP shielding with PIMF pair isolation to lower near-end crosstalk and susceptibility to external noise sources, improving signal integrity for demanding applications such as streaming and online gaming. The halogen-free outer jacket reduces toxic emissions in case of fire, and the 100.0 m spool length enables flexible routing and continuous runs without splices. Durable construction and consistent impedance characteristics support reliable Ethernet links and reduced packet loss.

Suitable for

• Gigabit Ethernet and PoE installations in homes and offices
• High-bandwidth applications: streaming, online gaming, and video conferencing
• Structured cabling runs up to 100 metres
• Environments where reduced fire-toxicity materials are required

Key specifications

• Category: Cat 6 performance class suitable for up to 1 Gbps Ethernet
• Shielding: S/FTP (overall braid + individually foil-shielded pairs)
• Pair construction: PIMF (Pairs in Metal Foil) for improved pair isolation
• Length: 100.0 metres on a single spool for uninterrupted runs
• Jacket material: halogen-free compound for lower toxic gas emission
• Conductor: twisted copper pairs designed for stable impedance and low attenuation

How to use

Measure and plan the cable route to keep runs within the recommended maximum length for Ethernet links. Terminate the cable with compatible Cat 6 connectors or keystone jacks following standard wiring schemes (T568A or T568B) and ensure proper shielding termination to maintain S/FTP effectiveness. Avoid tight bends, excessive pulling force, and proximity to high-voltage power lines to reduce interference and preserve cable integrity. Test the installed links with a network tester to verify continuity, pair assignments, and performance parameters.

Recommendations

For best results, use the cable in properly grounded installations and maintain correct connector shielding to fully benefit from S/FTP and PIMF protections. When planning long or high-density cable runs, allow service loops and leave slack at patch points to facilitate future maintenance and re-termination.