Magneetventiel voor HP-printers, OEM-reserveonderdeel

OEM solenoid designed for use in HP printers as a replacement electromechanical actuator. This component serves as a switchable coil that actuates paper handling mechanisms or internal mechanical movements in compatible HP models. It is intended for technicians and service centers performing maintenance or part replacement to restore or maintain printer mechanical functions.

Advantages

The solenoid provides direct electromechanical control with a compact form factor suitable for installation in constrained printer interiors. As an OEM replacement part, it matches the functional characteristics expected in HP service procedures, enabling consistent actuation force and reliable switching behavior. Its design supports straightforward integration into existing assemblies without requiring modifications to mounting points or electrical interfaces when used in compatible models.

Suitable for

• Repairing paper feed and pick mechanisms in compatible HP printers
• Replacing faulty or worn actuator coils that cause misfeeds or mechanical failures
• Routine maintenance by service centers and field technicians

Key specifications

• Type: Electromechanical solenoid (coil actuator)
• Function: Switchable coil for linear or plunger movement to control mechanical parts
• Compatibility: Designed for use in compatible HP printer models (refer to service documentation for exact fitment)
• Form factor: Compact module suitable for internal printer mounting
• Electrical interface: Standard two- or multi-pin connector for printer control signals (match connector type with the target model)
• Operation: Momentary actuation under controlled voltage/current as specified by the host printer

How to use

Power down the printer and disconnect it from mains before starting replacement. Access the internal assembly according to the printer's service manual, remove the defective solenoid assembly, and note connector orientation and mounting points. Install the replacement solenoid in the same position, secure any retaining screws or clips, and reconnect the electrical connector ensuring proper seating. Reassemble the printer panels, reconnect power, and run self-test or feed tests to verify correct operation of the paper handling or mechanical function controlled by the solenoid.

Recommendations

Use original service documentation to confirm compatibility and installation steps. Handle the solenoid and connectors with care to avoid bending pins or damaging insulation. If uncertain about fitment or electrical connections, consult an authorized service technician.