SATA-kabel Renkforce 1391528 50 cm – compatibel met Serial ATA 150/300/600

SATA cable Renkforce 1391528 is a 50 cm internal data cable designed to connect SATA storage devices to a motherboard. The cable supports Serial ATA transfer modes and is compatible with SATA 150, SATA 300 and SATA 600 standards, providing a reliable short-range connection for HDDs, SSDs and optical drives in desktop systems. Its compact length and standard connectors make it suitable for typical PC builds, upgrades and repairs where a straightforward, surge-free data link is required.

Advantages

The cable offers backward and forward compatibility across SATA 1.5 Gbit/s, 3.0 Gbit/s and 6.0 Gbit/s transfer rates, allowing flexible use with a wide range of storage devices. A 50 cm length balances reach and cable management inside most desktop cases, helping to reduce clutter and improve airflow. Standard SATA connectors ensure secure, keyed connections that align with common motherboard and drive ports.

Suitable for

• Connecting 2.5" and 3.5" SATA hard disk drives (HDDs)
• Connecting SATA solid-state drives (SSDs)
• Replacing a damaged or worn internal SATA cable in desktop PCs
• System assembly and upgrades in home and office desktops
• Connecting internal optical SATA drives

Key specifications

• Length: 50 cm
• Interface: Serial ATA (SATA)
• Compatibility: SATA I (1.5 Gbit/s), SATA II (3.0 Gbit/s), SATA III (6.0 Gbit/s)
• Connector type: standard straight SATA male connectors (drive-to-motherboard)
• Intended use: internal data connection for desktop storage devices

How to use

Power off the computer and disconnect it from the mains before installation. Locate the SATA port on the motherboard and the SATA data port on the storage device. Align the keyed SATA connectors and gently push each end into place until it seats securely; avoid forcing the connector. After connecting the data cable, reconnect the power cable to the drive and power on the system. Verify detection of the drive in BIOS/UEFI or your operating system and proceed with any required configuration, partitioning or formatting.

Recommendations

For optimal performance, use a direct, short routing inside the case to avoid sharp bends and interference from power cables. When upgrading to high-speed SATA III devices, ensure motherboard ports support SATA 6.0 Gbit/s to achieve maximum transfer rates. Replace cables that show visible wear, bent connectors or intermittent connectivity to maintain reliable data transfer.