SFP+ actieve optische kabel BlueOptics NW8DM AOC 10M, 10Gbps, 10 m

The SFP+ Active Optical Cable BlueOptics NW8DM AOC 10M, 10Gbps, 10 m is a pre-terminated fibre-optic direct-attach solution that connects SFP+ ports for 10 Gigabit Ethernet links. Designed for short- to mid-range interconnects, this 10 metre active optical cable delivers low latency and reduced power consumption compared with comparable copper twinax solutions. The plug-and-play design eliminates field termination and helps maintain clean cable management in racks and network cabinets.

Advantages

The cable provides a stable 10Gbps link using SFP+ interfaces with integrated transceivers, reducing the need for separate optical modules and patch cords. Its active optical construction enables longer reach and lower electromagnetic interference than copper alternatives, while the factory-terminated assembly ensures consistent optical performance and straightforward installation. The cable’s lightweight, flexible sheath simplifies routing in dense rack environments.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP+ AOC by inserting each SFP+ connector into the corresponding SFP+ port on network devices until the retention latch engages. No additional transceivers or patch cables are required. Ensure both device ports support SFP+ active optical cables and check link status via device management interfaces. Route the cable to avoid sharp bends and secure it within the cabinet to prevent stress on the connectors.

Recommendations

Verify compatibility with the network equipment vendor’s supported cable or SFP+ AOC list before deployment. Maintain a minimum bend radius as specified by industry guidance for fibre assemblies, avoid kinks, and keep connector end-faces clean to preserve optical performance. For best results in high-density environments, plan cable routing to minimize strain and allow adequate airflow.