SFP-transceiver BlueOptics 10-2279-01-BO 155 Mbit/s 1310 nm LC

The BlueOptics 10-2279-01-BO SFP transceiver is a compact fiber-optic module designed for 100BASE-FX Ethernet and similar optical applications. It supports a maximum data transfer rate of 155 Mbit/s over multi-mode fiber using a 1310 nm transmitter and receiver. The module uses an LC duplex connector, is housed in a metal casing with a silver finish, and is built to industry MSA form-factor standards to ensure interoperability with major networking hardware that supports the matching SFP type. Compliance with RoHS, FCC and CE standards and an MTBF of approximately 1,000,000 hours indicate a focus on long-term reliability.

Advantages

The BlueOptics SFP offers stable 155 Mbit/s optical transmission at 1310 nm combined with an LC connector in a standard SFP metal housing, enabling straightforward integration into switches, routers and storage systems that accept MSA-compliant modules. The module is manufactured using high-quality optical and electronic components to provide extended operational lifetime and consistent signal performance. RoHS, FCC and CE conformity supports safe deployment across a range of professional network environments.

Suitable for

• 100BASE-FX Ethernet links over multi-mode fiber up to ~2 km
• Interconnects between switches, routers and storage systems with LC ports
• Replacement or upgrade of MSA-compliant SFP ports in enterprise network equipment
• Use in environments requiring RoHS, FCC and CE compliant optical transceivers

Key specifications

• Maximum data transfer rate: 155 Mbit/s
• Wavelength (Tx/Rx): 1310 nm
• Connector type: LC duplex
• Housing: metal (silver colour)
• Typical reach: up to approximately 2 kilometres over suitable multi-mode fiber
• Mean time between failures (MTBF): ~1,000,000 hours

How to use

Insert the SFP transceiver into an empty MSA-compliant SFP slot on compatible network equipment until it latches. Connect LC duplex fiber patch cords with matching polarity to the module’s LC ports. Ensure the host device is configured for the intended Ethernet or optical protocol and that firmware or driver settings allow third-party SFP modules if required. Verify link status with the host device indicators or management interface and perform basic tests such as ping and throughput checks to confirm proper operation.

Recommendations

Use high-quality LC duplex fiber patch cords and, where applicable, patch panels to achieve optimal optical performance. Confirm that the host device supports the module’s data rate and wavelength and, if needed, enable digital diagnostics (DDM/DOM) support on compatible hardware to monitor voltage, temperature, laser bias and optical power for easier maintenance and troubleshooting.