SFP-transceiver BlueOptics MGBIC-LC03-BO 1000 Mbit/s 1310 nm

The BlueOptics MGBIC-LC03-BO SFP transceiver is a single‑port, compact module designed for 1000 Mbit/s fiber connections over a 1310 nm wavelength. Housed in a stainless steel casing, this SFP transceiver provides a standardized interface for hot‑pluggable insertion into compatible network equipment and supports reliable optical links for typical enterprise and carrier environments. The module is intended to extend or connect Gigabit Ethernet and other 1 Gbps fiber links using LC connectors and standard SFP sockets.

Advantages

The BlueOptics MGBIC-LC03-BO combines a compact SFP form factor with a stainless steel housing that offers mechanical durability and consistent performance. Operating at 1310 nm and supporting up to 1000 Mbit/s makes it suitable for established singlemode fiber runs where stable, low‑latency data transmission is required. Its hot‑pluggable design simplifies installation and replacement without powering down equipment.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP transceiver into an empty SFP slot on compatible network equipment until it clicks into place. Connect singlemode fiber cables with LC connectors to the transceiver ports, ensuring correct polarity. Verify link status on the host device and configure port settings as required for 1 Gbps operation. To remove the module, unlock any retention mechanisms and pull the transceiver straight out while the system is powered if the device supports hot‑swap; otherwise power down the equipment before removal.

Recommendations

Use clean, properly terminated singlemode fiber cables and follow manufacturer guidelines for fiber handling and ESD protection. Match the module's wavelength and fiber type to the existing infrastructure, and verify compatibility with the host device's SFP module list when possible to ensure full functionality.