SFP-transceiver BlueOptics SFP-10GE-LRM 10000 Mbit/s 1310 nm

The BlueOptics SFP-10GE-LRM 10000 Mbit/s 1310 nm is an SFP+ fiber optic transceiver module engineered for 10 Gigabit Ethernet links over multimode fiber. Operating at a wavelength of 1310 nm and supporting a maximum data rate of 10,000 Mbit/s, this module is intended for short- to medium-reach network connections where reliable, standards-based optical interface is required. The compact SFP+ form factor allows straightforward installation into compatible switch or router ports and integration into existing network infrastructure.

Advantages

This SFP+ transceiver provides a standardized fiber interface with a small form factor that saves space in equipment bays. It supports high data throughput at 10 Gbit/s while using the 1310 nm wavelength for compatibility with multimode fiber deployments. The module is vendor-neutral in design for use with a wide range of network equipment and is simple to install and replace without major configuration changes.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP-10GE-LRM module into a compatible SFP+ slot on your switch, router or network interface card while the host device is powered down or hot-pluggable according to the equipment manual. Connect the appropriate multimode fiber cable with matching LC connector, ensure correct fiber polarity, and verify link status through the host device management interface. No special configuration on the transceiver itself is required; any needed link settings are handled by the host equipment.

Recommendations

Confirm compatibility with the host device and use multimode fiber rated for LRM reach to achieve expected link performance. Keep fiber connectors clean and follow ESD precautions when handling the module. Monitor link LEDs or management software after installation to verify stable operation.