SFP-transceiver BlueOptics USFP-GB/M-D-R-BO 1250 Mbit/s glasvezel

The BlueOptics USFP-GB/M-D-R-BO is an SFP fiber optic transceiver designed for 1000Base-SX multimode links with a maximum data rate of 1250 Mbit/s. Housed in a metal enclosure and weighing approximately 20 g, the module follows MSA mechanical standards for hot-pluggable SFP ports and provides a reliable interface for switches, routers and storage systems that accept standard SFP optics. Its construction and specified MTBF of 1,000,000 hours support long-term deployments and continuous operation in network environments.

Advantages

The transceiver offers a compact SFP form factor and a metal housing for mechanical stability and thermal dissipation. With support for 1250 Mbit/s signalling and a multimode optical interface it enables simultaneous transmit and receive operation over LC duplex connections. The stated MTBF and the lightweight silver-coloured housing contribute to predictable service life and ease of installation in dense networking equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP transceiver into an appropriate SFP slot on a switch, router or other networking device while the device is powered according to the host manufacturer’s guidelines for hot-pluggable modules. Connect LC duplex multimode fiber patch cords to the transceiver’s optical ports, ensuring correct TX/RX orientation. Verify link status and data rate in the host device’s management interface; ensure the connected hardware supports 1000Base-SX optics. To avoid contamination and signal loss, keep protective caps on the fiber connectors when not in use and clean connector endfaces before mating.

Recommendations

Use the transceiver with multimode fiber and LC duplex patch cords rated for 850 nm operation, confirm compatibility with the host device’s SFP support list, and follow the host vendor’s guidance for firmware and DDM/DOM support if diagnostic monitoring is required.