SFP-transceivermodule BlueOptics 10-2300-01-BO 1250 Mbit/s

The BlueOptics 10-2300-01-BO 1250 Mbit/s is an SFP fiber optic transceiver module designed for small form-factor pluggable applications. It supports a maximum data transfer rate of 1250 Mbit/s and uses the SFP form factor to provide a compact, hot-pluggable interface for network equipment. The module is finished in silver, weighs approximately 20 g, and is built to industry standards for interoperability and reliability.

Advantages

This transceiver offers a standardized SFP interface for straightforward installation and compatibility with a wide range of switches and routers. With a rated mean time between failures (MTBF) of 1,000,000 hours and compliance with CE, FCC and RoHS standards, the module is suitable for deployments where regulatory conformity and long-term operation are important. Its compact SFP form factor enables dense port packing and easy replacement without powering down equipment.

Suitable for

• Upgrading or expanding SFP-capable switches and routers
• Short- to medium-range fiber optic links in enterprise networks
• Patch panels and transceiver bays where compact, hot-pluggable modules are required
• Network equipment testing and lab environments

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Form factor: SFP module
• Product colour: Silver
• Weight: 0.02 kg
• Reliability: MTBF 1,000,000 hours
• Regulatory compliance: CE, FCC, RoHS

How to use

Power down equipment only if required by the switch or router manufacturer; otherwise insert the SFP module into an available SFP slot until it clicks into place. Connect the appropriate fiber patch cord to the module’s optical interface, ensuring correct connector type and polarity. After insertion and connection, verify link status through the host device’s management interface or LED indicators and configure the port for the required speed and duplex settings if applicable. Remove the module by releasing the latch or tab and gently pulling it out when the device is powered down or when hot-swap is supported.

Recommendations

Use compatible SFP slots and approved fiber patch cords; avoid excessive bending of fiber cables and protect connector end-faces from dust. Observe electrostatic discharge (ESD) precautions during handling and store unused transceivers in protective caps or anti-static packaging to maintain optical performance and longevity.