SFP+-transceivermodule BlueOptics 1442401G1 10000 Mbit/s 850 nm

The BlueOptics 1442401G1 SFP+ transceiver module is designed for high-speed fiber optic links, supporting a maximum data transfer rate of 10000 Mbit/s over multimode fiber at an operating wavelength of 850 nm. This compact SFP+ form-factor module provides a hot-pluggable interface for 10G Ethernet and other high-bandwidth connections, allowing straightforward integration into compatible switches, routers and optical patch panels. The module is intended to deliver stable connectivity and predictable performance in server rooms, data centers and enterprise networks.

Advantages

The SFP+ module offers a standardized SFP+ interface for easy insertion and removal without powering down equipment, and its 850 nm wavelength is optimized for short-reach multimode fiber links. With support for 10000 Mbit/s throughput, the transceiver accommodates 10G Ethernet traffic and similar high-speed protocols while maintaining a small footprint that conserves port density in network devices.

Suitable for

• 10G Ethernet connections over multimode fiber in data centers
• High-bandwidth uplinks between switches and routers
• Server-to-switch links in enterprise networks
• Optical patch panel and fiber aggregation deployments

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbps)
• Operating wavelength: 850 nm
• Form factor: hot-pluggable SFP+ transceiver
• Optimized for short-reach multimode fiber links

How to use

Install the BlueOptics SFP+ transceiver into an empty SFP+ port on a compatible switch, router or network interface card until it clicks into place. Connect the multimode fiber cable with the appropriate LC connector to the module. Confirm link status via the host device management interface and verify that the port is configured for 10G operation if required. To remove, power down the relevant port if recommended by the equipment vendor, release the module latch and gently pull the transceiver out.

Recommendations

Use multimode fiber compatible with 850 nm transmission and ensure fiber connectors are clean to maintain signal quality. Verify compatibility with your network equipment vendor's supported transceiver list and configure the host port for 10G operation. Avoid excessive mechanical stress on the transceiver or connected fiber to prevent damage.