SFP+-transceivermodule BlueOptics 407-10942-BO 10000 Mbit/s 850 nm

The BlueOptics 407-10942-BO SFP+ transceiver module provides 10 Gbit/s optical connectivity over multimode fiber using an 850 nm wavelength. Designed to fit SFP+ ports with an LC duplex connector and to comply with MSA mechanical and electrical requirements, this compact silver module weighs approximately 20 g and supports short-range 10GBASE-SR links. The module is RoHS and CE compliant and intended for integration into network switches, routers, storage systems and other devices that accept standard SFP+ transceivers.

Advantages

The transceiver supports a 10000 Mbit/s data rate and implements both transmitter and receiver at 850 nm for bidirectional optical signaling over multimode fiber. Its SFP+ interface and LC duplex connector follow MSA conventions to ensure mechanical compatibility with a wide range of hardware platforms. The module's compact form factor and low weight enable easy hot-plug installation, while adherence to CE and RoHS standards addresses regulatory and environmental requirements.

Suitable for

• Short-range 10G Ethernet links (10GBASE-SR) over multimode fiber
• High-speed server, switch and storage interconnects
• Data center uplinks and aggregation ports
• Environments requiring MSA-compliant SFP+ modules

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 850 nm
• Connector: LC duplex
• Fiber type: multimode fiber (MMF), designed for short-range links
• Device colour/finish: silver
• Weight: approximately 0.02 kg
• Compliance: RoHS, CE

How to use

Insert the BlueOptics SFP+ transceiver into a compatible SFP+ slot on your switch, router or storage device until it clicks into place, then secure any retention mechanism present on the host. Connect LC duplex multimode fiber patch cables to the transceiver, ensuring correct transmit/receive orientation. Verify link status and speed through the host device management interface. For best results, use compatible multimode fiber and check that the target hardware supports 10GBASE-SR and SFP+ modules with digital diagnostic monitoring if those features are required.

Recommendations

To maximise link performance and longevity, install the transceiver in a static-safe environment, use high-quality multimode patch cords and maintain proper bend radius on fibers. If digital diagnostic monitoring is required, confirm the host system exposes DDM/DOM parameters. For short-range 10G links keep multimode fiber runs within vendor-recommended distance limits for 850 nm optics.