SFP-transceivermodule BlueOptics 852-1200-BO 1250 Mbit/s glasvezel

The BlueOptics 852-1200-BO SFP transceiver module is a compact fiber optic interface designed for use in network equipment that accepts SFP form-factor modules. Supporting a maximum data transfer rate of 1250 Mbit/s, this module provides a lightweight, silver-coloured optical connection option suitable for standard fiber links. At approximately 20 g, the transceiver is easy to install and handle while offering a straightforward solution for extending fiber connectivity in switches, routers and media converters that support SFP modules.

Advantages

The module supports a defined SFP interface and a maximum throughput of 1250 Mbit/s, delivering compatible performance for common fiber-based network segments. Its small SFP form factor and low weight simplify installation in dense equipment bays and patch panels. The neutral silver finish aids visual identification without affecting interoperability. The BlueOptics design focuses on compatibility with standard SFP slots and stable optical link performance for typical enterprise, telecom and industrial networking environments.

Suitable for

• Upgrading switches or routers with SFP fiber ports
• Connecting media converters to fiber networks
• Establishing short- to medium-distance fiber links in LANs
• Replacing failed SFP transceivers with a compatible module

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Weight: 0.02 kg (approximately 20 g)
• Product colour: Silver

How to use

Power down or follow hot-swap procedures recommended by your network equipment vendor before inserting the SFP module into an available SFP slot. Align the module with the slot connector and press gently until it clicks into place; secure any retention latch if present. Connect the appropriate fiber optic cable to the transceiver’s optical port, observing transmit/receive orientation. Configure the host device as required for the optical interface and verify link status and speed in the device management interface. To remove the module, release the latch and pull the transceiver straight out, protecting the optical ports with dust caps when not in use.

Recommendations

Use industry-standard single-mode or multimode fiber and compatible connectors as specified by your network design. Ensure cleanliness of optical connectors and observe ESD precautions during handling. Confirm that the host equipment supports SFP modules at 1250 Mbit/s and check device firmware for any compatibility notes before deployment.