SFP+ transceivermodule BlueOptics BTI-10GZR-DD-SFP+-BO 10000 Mbit/s

The BlueOptics BTI-10GZR-DD-SFP+-BO is a fiber optic SFP+ transceiver module designed for 10 Gbit/s network links. The module follows the SFP+ form factor and provides a maximum data transfer rate of 10000 Mbit/s. With a silver housing and a lightweight design of approximately 20 g, this transceiver is suitable for compact switches, routers and optical line cards where space and compatibility with SFP+ ports are required. The manufacturer specifies a mean time between failures (MTBF) of 1,000,000 hours, indicating an emphasis on reliable continuous operation in network deployments.

Advantages

The transceiver supports the SFP+ interface standard, enabling 10 Gbit/s connectivity in devices with SFP+ cages. Its compact SFP+ form factor and low weight make it easy to install in high-density racks and modular networking equipment. The silver metal housing provides basic mechanical protection and thermal conduction, while the high MTBF value reflects expected long-term reliability suitable for enterprise or service-provider environments.

Suitable for

Key specifications

How to use

Before installation, ensure the host device supports SFP+ transceivers and that the optics type matches the fiber cabling in use. Power down or follow hot-swap procedures recommended by the host equipment manufacturer. Insert the module into an SFP+ port until it clicks into place, and connect the fiber patch cable to the transceiver port. Configure the network device interfaces as required for 10 Gbit/s operation and verify link status through the device management interface. To avoid contamination, keep dust caps on unused transceiver ports and handle fiber connectors by the boot or connector body.

Recommendations

Use the BlueOptics SFP+ transceiver in compatible SFP+ ports and with fiber patch cables that match the transceiver optical specifications. Follow ESD precautions when handling the module, and verify compatibility with the host device firmware if vendor locking is a concern. Store unused modules in anti-static bags and replace dust caps after disconnecting fiber to maintain connector cleanliness and signal integrity.