SFP-transceivermodule BlueOptics FL-SFP-WDM10-A-BO 1250 Mbit/s

The BlueOptics FL-SFP-WDM10-A-BO 1250 Mbit/s is a single-port fiber optic SFP transceiver module designed for use in small-form-factor networking equipment. It supports a maximum data transfer rate of 1250 Mbit/s and is supplied in a silver metal housing with an SFP form factor. The module is intended for optical connections where compact size and standard SFP compatibility are required and carries regulatory compliance for RoHS, FCC and CE. It is lightweight and sold individually.

Advantages

This SFP transceiver offers a compact SFP form factor that fits a wide range of switches, routers and media converters. With a rated data rate of 1250 Mbit/s it supports standard fiber-based Ethernet and serial fiber links. The silver metal housing contributes to mechanical durability while the low unit weight simplifies handling and installation. Compliance with RoHS, FCC and CE standards indicates adherence to environmental and safety requirements. The high MTBF value of 3,000,000 hours reflects design focus on long-term reliability in continuous operation.

Suitable for

Key specifications

How to use

Before installation, ensure the network device supports SFP modules and is powered down unless the device supports hot-plugging. Remove the protective dust caps from both the module and the fiber connector. Insert the BlueOptics SFP module into the device SFP slot until it latches securely. Connect the appropriate fiber patch cable to the transceiver and restore power to the host device if it was shut down. Verify link and activity LEDs on the host to confirm a successful optical link. Follow any vendor-specific instructions for port enabling or configuration in the switch or router management interface.

Recommendations

Handle the transceiver by its housing, avoid touching the optical interface, and keep dust caps on when not in use. Store and operate the module within the temperature and humidity ranges specified by the host device documentation. Use compatible single-mode or multimode fiber cabling as required by the optical characteristics of the specific WDM variant being deployed. For reliable operation, verify compatibility with the host equipment and firmware before mass deployment.