SFP+-transceivermodule BlueOptics LPe12100-OPT 10000 Mbit/s 850 nm

The BlueOptics LPe12100-OPT 10000 Mbit/s 850 nm is an SFP+ transceiver module engineered for short-range fiber optic links. Designed to support a maximum data transfer rate of 10 Gbit/s, this compact module uses an 850 nm wavelength and a standard SFP+ interface to provide high-speed connectivity between switches, servers and optical patch panels. Supplied as a single pack, the module is intended for straightforward installation into compatible SFP+ ports and for use in data centre uplinks, aggregation links and short-reach fibre runs.

Advantages

The module offers 10 Gbit/s throughput over multimode fibre using an 850 nm VCSEL light source, delivering low-latency, reliable transmission for short distances. Its SFP+ form factor ensures wide compatibility with a broad range of network equipment supporting hot-pluggable transceivers. The single-pack format provides a simple procurement option while the industry-standard interface and optical wavelength make it suitable for common short-range connectivity scenarios.

Suitable for

Key specifications

How to use

Insert the BlueOptics SFP+ module into a compatible SFP+ port until it latches, then connect the appropriate multimode fibre patch cable terminated for 850 nm operation. Ensure both ends of the fibre link are clean and that connected equipment is configured to use a 10 Gbit/s optical port. After insertion, verify link status and port speed through your switch or server management interface and perform any required diagnostics or link tests.

Recommendations

Use high-quality multimode fibre and follow standard fibre handling procedures: keep connectors clean, use dust caps when not connected, and avoid tight bends. Verify compatibility with the host device and firmware to ensure proper link negotiation at 10 Gbit/s. For optimal performance, use this module on short-reach multimode links consistent with 850 nm VCSEL transceiver best practices.