SFP-transceivermodule BlueOptics RDH90120/D0210-I-BO 1250 Mbit/s LC

The BlueOptics RDH90120/D0210-I-BO SFP transceiver module is a compact 1000BASE-LX optical module designed for single-mode fiber networks. It supports a maximum data transfer rate of 1250 Mbit/s and uses an LC duplex interface for simultaneous transmit and receive over separate fibers. The module is offered in a silver housing, weighs approximately 0.02 kg, and meets CE, RoHS and FCC conformity requirements for safe and reliable installation in networking equipment.

Advantages

This SFP transceiver provides compatibility with MSA-compliant sockets and common hardware platforms that accept 1000BASE-LX SFP modules. Its LC duplex interface and single-mode operation enable longer reach links while remaining compact and easy to install. Compliance with CE, RoHS and FCC standards supports deployment in regulated environments, and the lightweight metal enclosure simplifies insertion and removal from switch or router SFP ports.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP transceiver into an available SFP slot on a compatible switch, router or other network device while the device is powered according to the manufacturer’s instructions for hot-swap modules. Connect the LC duplex single-mode patch cord to the module, ensuring correct transmit/receive orientation. Configure the host device to enable the SFP port and set any required link parameters such as speed or auto-negotiation. Verify link status and traffic flow using the device management interface or indicator LEDs.

Recommendations

For best results, use single-mode LC patch cords and terminate to compatible SFP or patch-panel ports; ensure the host device supports 1000BASE-LX SFP modules and, where applicable, the DDM/DOM diagnostic interface if you require digital monitoring. Avoid exposing fiber connectors to dust and keep transceiver and cable dust caps in place when not connected.