SFP-transceivermodule BlueOptics SBC-5XXX-SFPSM 1250 Mbit/s 1310 nm

The BlueOptics SBC-5XXX-SFPSM 1250 Mbit/s 1310 nm is a fiber optic SFP transceiver module designed for point-to-point and short-range network links. It supports a maximum data transfer rate of 1250 Mbit/s and transmits at a wavelength of 1310 nm. The module is compact and lightweight (20 g) with a silver housing, intended for installation in SFP-compatible network equipment to extend or replace optical ports.

Advantages

This SFP transceiver offers a standardized SFP interface for broad compatibility with switches, routers and media converters that accept hot-pluggable modules. Its 1310 nm optical wavelength and 1250 Mbit/s rate make it suitable for common fiber links, while the lightweight silver housing ensures minimal additional load and easy handling during installation. The module is suitable for reliable optical connections where single-fiber or short-reach multimode/single-mode links are required.

Suitable for

• Upgrading or repairing SFP ports on network switches and routers
• Establishing short- to medium-range fiber optic links
• Use in media converters and optical networking equipment
• Laboratory setups and testing where a 1310 nm SFP module is required

Key specifications

• Interface type: SFP (Small Form-factor Pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Optical wavelength: 1310 nm
• Weight: 0.02 kg (20 g)
• Color: Silver

How to use

Power down the host device or follow the vendor's hot-plug procedures, then insert the SFP transceiver into an empty SFP cage until it clicks into place. Connect the appropriate optical fiber patch cable to the module's connector, observing correct fiber type and connector end-face cleanliness. Configure the host device's interface settings as required for a 1250 Mbit/s link and verify link status and optical parameters via the device management interface.

Recommendations

Use compatible single-mode or multimode fiber and ensure connectors are clean before mating. Follow equipment vendor guidelines for hot-plug insertion and removal, and verify transceiver compatibility with the host device's supported SFP modules to avoid interoperability issues.