SFP-transceivermodule BlueOptics SBC-SFPCOPPER-1G-BO 1250 Mbit/s RJ-45

The BlueOptics SBC-SFPCOPPER-1G-BO is an SFP transceiver module with an RJ-45 interface that supports data rates up to 1250 Mbit/s. Housed in a compact silver metal casing and weighing approximately 20 g, this module follows MSA mechanical and electrical standards to ensure interoperability with compatible network equipment. The transceiver is intended for copper Ethernet links and is designed for reliable operation with an MTBF of 1,000,000 hours.

Advantages

This BlueOptics SFP module provides a standardized RJ-45 copper interface in an SFP form factor, enabling flexible port-level upgrades on switches, routers and other network devices that accept MSA-compliant SFP modules. The metal housing offers mechanical protection and thermal conduction while the low weight simplifies installation. Support for up to 1250 Mbit/s makes the module suitable for gigabit Ethernet and related high-speed applications over typical copper cabling distances.

Suitable for

Key specifications

How to use

Power down or follow hot-swap procedures recommended by the host device, then insert the SFP module into an available SFP slot until it latches. Connect a compatible RJ-45 copper cable to the module and to the remote device. Configure link settings (speed/duplex/auto-negotiation) on both ends according to your network requirements. Verify link status and diagnostics via the host device interface. Observe static precautions and handle the module by its housing to avoid damage to internal components.

Recommendations

For reliable operation, use quality CAT5e/CAT6/CAT6A copper cabling and keep cable runs within recommended distance limits for gigabit Ethernet. Ensure the host device firmware supports third-party RJ-45 SFP modules and enable any required digital diagnostic monitoring features if supported for link health checks.