SFP-transceivermodule BlueOptics SFP-1G-EX-IT 1250 Mbit/s 1550 nm

The BlueOptics SFP-1G-EX-IT 1250 Mbit/s 1550 nm is a compact fiber optic SFP transceiver module designed for single-mode optical links. With a maximum data transfer rate of 1250 Mbit/s and an operating wavelength of 1550 nm, this module offers a lightweight and space-saving solution for network equipment that supports SFP ports. The module’s silver housing and standard SFP form factor enable broad compatibility with switches, routers and optical equipment that accept hot‑swappable SFP modules.

Advantages

This SFP transceiver provides consistent data throughput up to 1250 Mbit/s while maintaining low physical weight (0.04 kg) and a compact SFP interface. The 1550 nm wavelength is suitable for longer single‑mode fiber runs and environments where reduced attenuation is required. Its standard SFP form factor supports easy installation and hot‑swap replacement without powering down compatible network devices.

Suitable for

• Single‑mode fiber connections in LAN and MAN environments
• Upgrading or expanding SFP-equipped switches and routers
• Optical uplinks between network racks and data cabinets
• Point-to-point fiber links requiring 1550 nm wavelength

Key specifications

• Interface type: SFP small form‑factor pluggable
• Maximum data transfer rate: 1250 Mbit/s
• Operating wavelength: 1550 nm
• Suitable fiber type: single‑mode fiber (SMF)
• Form factor: hot‑swappable SFP module
• Colour: silver
• Weight: 0.04 kg

How to use

Install the BlueOptics SFP-1G-EX-IT by inserting the module into a compatible SFP slot on a switch, router or optical transceiver cage until it clicks into place. Connect the single‑mode fiber cable with the appropriate connector type for your equipment. The module supports hot‑swap operation; however, follow your device manufacturer’s guidelines for link negotiation and port configuration. Configure the network interface for the desired speed and duplex settings if manual configuration is required.

Recommendations

Use this module with verified single‑mode fiber and connectors to ensure optimal optical performance. Observe electrostatic discharge (ESD) precautions during handling and keep protective caps on fiber connectors when not connected. Verify compatibility with your network equipment vendor’s supported transceiver list to avoid interoperability restrictions.