SFP-transceivermodule BlueOptics SFP-GLS-10A-A 1250 Mbit/s 1310 nm

The BlueOptics SFP-GLS-10A-A is a compact fiber optic SFP transceiver module that supports a maximum data transfer rate of 1250 Mbit/s and transmits at a wavelength of 1310 nm. Designed for use in fiber-based network links, the module provides a lightweight and standardized SFP form factor for straightforward insertion into compatible switch, router or media converter SFP ports. With a silver metal housing and a weight of approximately 20 g, this transceiver is suited to installations where consistent single-mode or multimode fiber connectivity at 1310 nm is required.

Advantages

The module follows the SFP interface standard for hot-pluggable installation, allowing quick replacement or upgrades without powering down network devices. Its 1250 Mbit/s data rate and 1310 nm transmission wavelength make it appropriate for a wide range of short- to medium-range fiber links. The compact and lightweight metal housing provides mechanical stability and thermal dissipation while maintaining a low profile in rack-mounted or modular equipment.

Suitable for

• Fiber uplinks between switches and routers
• Connections to media converters and SFP-equipped devices
• Point-to-point fiber links in campus and enterprise networks
• Network segments requiring 1310 nm transmission

Key specifications

• Interface type: SFP (small form-factor pluggable)
• Maximum data transfer rate: 1250 Mbit/s
• Optical wavelength: 1310 nm
• Housing: metal, silver colour
• Weight: 0.02 kg
• Form factor: hot-pluggable transceiver module

How to use

Insert the BlueOptics SFP-GLS-10A-A into an empty SFP slot on a compatible switch, router or media converter until it seats securely. Connect the appropriate fiber optic cable (matching single-mode or multimode type as required for your link) to the transceiver’s optical port, ensuring correct connector type and polarity. After insertion and cable connection, confirm link status through the host device’s management interface or LED indicators. To remove the module, follow the host device procedure for safe hot-unplug if required and pull the transceiver straight out by its housing.

Recommendations

Use factory-terminated fiber cables and ensure connectors are clean before mating to avoid signal loss. Verify that the host device supports transceiver modules of this type and that the selected fiber type and connector match the expected 1310 nm link requirements. Store unused transceivers in anti-static packaging and avoid exposure to extreme temperatures or moisture.