SFP-transceivermodule BlueOptics SFP10G-T-BO koper 10000 Mbit/s RJ-45

The BlueOptics SFP10G-T-BO is a copper SFP+ transceiver module with an RJ-45 interface designed for 10G Ethernet links. In a compact SFP+ form factor and weighing approximately 20 g, it supports a maximum data transfer rate of 10000 Mbit/s and a copper link distance up to 30 m. The module is intended for installation in compatible SFP+ ports to provide reliable 10G connectivity where RJ-45 copper cabling is used.

Advantages

The module combines the small SFP+ form factor with an RJ-45 connector, enabling high-speed 10GBASE-T connections over copper cabling without requiring a larger port footprint. Its lightweight design and standardized SFP+ dimensions simplify installation and replacement in network equipment. The transceiver supports common diagnostic features and is built to operate within the electrical and physical constraints of typical networking hardware.

Suitable for

Key specifications

How to use

Insert the SFP10G-T-BO transceiver into a compatible SFP+ slot on the networking device while the device is powered down or following the manufacturer's hot-swap guidance. Connect a suitable Cat6A/Cat7 RJ-45 copper cable to the module and to the peer port. Ensure that the host device firmware or software accepts third-party SFP+ modules if required. After physical installation, verify link negotiation and 10G operation using the host device management interface and perform any necessary configuration for speed and duplex settings.

Recommendations

Use high-quality shielded copper cabling (Cat6A or better) for reliable 10G performance up to the specified 30 m distance, and verify that the network equipment supports RJ-45 SFP+ modules and any diagnostic functions you intend to use.