SFP-transceivermodule BlueOptics SFP10G-TR85-A-BO glasvezel SFP+ LC

The BlueOptics SFP10G-TR85-A-BO Fiber Optic SFP+ LC is a 10 Gigabit Ethernet SFP+ transceiver module designed for short-range multimode fiber connections. Constructed with an aluminum housing and weighing approximately 20 g, this module implements a duplex LC connector and supports data rates up to 10 Gbps over multimode fiber. It is engineered to operate reliably over distances up to 300 m and to comply with MSA SFP+ form-factor expectations for straightforward integration into compatible network switches, routers and storage systems.

Advantages

This SFP+ transceiver provides stable 10 Gigabit Ethernet performance with low weight and a compact aluminum housing for efficient heat dissipation. The LC duplex connector and multimode 850 nm optics enable simultaneous transmit and receive channels, reducing cabling complexity. The module is manufactured to meet MSA alignment and electrical requirements to aid compatibility with a wide range of vendor hardware and supports reliable short-reach optical links with predictable performance.

Suitable for

Key specifications

How to use

Insert the transceiver into an SFP+ slot on a compatible switch, router or storage device until it latches. Connect LC duplex multimode patch cables to the module's LC ports, ensuring transmit and receive fibers are correctly crossed if required. Power on the host device and verify link status through the device management interface; the module negotiates 10 Gbps operation with the connected port. If the host supports digital diagnostic monitoring (DDM/DOM), enable the feature to monitor supply voltage, laser bias, transmit power, receive power and temperature where supported by the hardware.

Recommendations

Use OM3/OM4 multimode patch cables for best short-range performance and keep fiber connectors clean to maintain signal quality. Confirm compatibility with your network equipment vendor and, when possible, test a single module in your environment before large deployments to ensure firmware and DDM/DOM support.