SFP-transceivermodule BlueOptics SFP28-25G-ERL-30-HU-BO 25000 Mbit/s

The BlueOptics SFP28-25G-ERL-30-HU-BO is a fiber optic SFP transceiver module engineered for 25 Gbit/s Ethernet links. Designed for data center and enterprise networking, this SFP28 device provides a compact pluggable form factor and supports high-speed single-lambda transmission. The module is intended for use in systems that accept SFP28 interfaces and offers compatibility with a range of switches, routers and host adapters that support 25G SFP28 optics.

Advantages

This SFP28 transceiver delivers stable 25,000 Mbit/s throughput in a small, hot-pluggable SFP28 package, reducing port density and cabling complexity in high-density racks. The fiber optic design enables long-reach links suitable for inter-rack or inter-site connections while maintaining low latency and signal integrity. Its standardized SFP28 interface ensures straightforward replacement or upgrade of existing 10G/25G ecosystems without major system changes.

Suitable for

• Data center spine and leaf interconnects
• High-performance server uplinks
• Carrier and metro fiber links requiring 25G throughput
• Switch-to-switch connections in enterprise networks

Key specifications

• Interface type: SFP28
• Maximum data transfer rate: 25000 Mbit/s (25 Gbit/s)
• Optical medium: single-mode fiber (typical for ERL-class optics)
• Form factor: SFP28 small form-factor pluggable
• Application: 25G Ethernet links, long-reach fiber connectivity

How to use

Install the BlueOptics SFP28-25G-ERL-30-HU-BO by inserting the module into an SFP28-compatible port on a switch, router or network card until it clicks into place. Connect a compatible single-mode fiber cable to the transceiver optical ports, observing correct polarity. Ensure the host device is configured for 25G operation and verify link status through the equipment management interface. For removal, depress the release latch and pull the module straight out while following standard hot-swap procedures.

Recommendations

Use this transceiver with compatible SFP28-capable network equipment and single-mode fiber cabling rated for the expected link length. Verify firmware or compatibility lists from your network equipment vendor before deployment and perform link tests after installation to confirm expected 25G performance and optical power margins.