SFP+-transceivermodule BlueOptics SRX-SFPP-10G-SR-ET-BO 10000 Mbit/s 850 nm

The BlueOptics SRX-SFPP-10G-SR-ET-BO is an SFP+ fiber optic transceiver module engineered for short-range 10 Gbit/s data transmission over multimode fiber. It operates at an 850 nm wavelength, uses an LC duplex connector and is housed in a durable metal casing. The module accepts a 3.3 V input and has a compact, lightweight form factor, making it suitable for installation in network switches, routers and storage systems that support 10GBASE-SR SFP+ modules.

Advantages

This SFP+ module supports 10 Gbit/s data rates over multimode fiber and is built to MSA standards for physical compatibility. Its metal housing provides mechanical stability and thermal dissipation while maintaining a low weight. The transceiver implements transmit and receive elements at 850 nm for short-reach links and offers Digital Diagnostics Monitoring (DDM/DOM) for real-time monitoring of parameters such as supply voltage, laser bias current, optical power and temperature when the host hardware supports this feature.

Suitable for

• Short-range 10 Gbit/s Ethernet connections (10GBASE-SR) over multimode fiber
• Interconnects between switches, routers and storage systems in data centers
• High-bandwidth server-to-switch uplinks and aggregation links

Key specifications

• Interface type: SFP+
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Wavelength: 850 nm
• Connector: LC duplex
• Suitable fiber type: Multimode fiber (MMF)
• Power supply: 3.3 V input
• Product colour: Silver; metal housing
• Typical reach: short-range multimode links (up to typical MMF distances for 10GBASE-SR; verify with system requirements)
• Digital Diagnostics Monitoring (DDM/DOM): supported when host hardware provides the interface

How to use

Insert the SFP+ transceiver into a compatible SFP+ port on the switch, router or storage device following the host vendor’s hot-plug instructions. Connect LC duplex multimode fiber patch cords to the transceiver’s LC connector, ensuring correct transmit-to-receive alignment with the remote transceiver. Confirm that the connected devices are configured for 10GBASE-SR operation and that any required DDM/DOM support is enabled in the host system to read diagnostic values. Observe electrostatic discharge (ESD) precautions and keep dust caps on the transceiver until final connection to protect the optical interface.

Recommendations

Use high-quality multimode fiber patch cords and, when possible, test links end-to-end after installation. Verify host compatibility with 10GBASE-SR SFP+ modules and enable DDM/DOM in supported hardware to monitor operating parameters. For reliable performance, follow the switch or router vendor guidance on supported third-party transceivers and maintain clean connectors to avoid signal loss.