SFP+ transceivermodule BlueOptics TN-10GSFP-LR4M-BO 10000 Mbit/s 1310 nm

The BlueOptics TN-10GSFP-LR4M-BO is an SFP+ fiber-optic transceiver module designed for single-mode links and 10GBASE-LR applications. It supports a maximum data transfer rate of 10,000 Mbit/s over single-mode fiber with a nominal wavelength of 1310 nm. The compact metal housing and 3.3 V operating voltage make the module suitable for installation in SFP+ ports of switches, routers and storage systems that follow MSA SFP+ form-factor specifications. With an LC duplex connector and a lightweight silver housing, the transceiver enables simultaneous transmit and receive operation over two fibers for long-reach optical connections.

Advantages

The module provides compatibility with standard SFP+ ports and supports high-speed 10 Gbit/s Ethernet and other optical protocols over single-mode fiber. Its metal enclosure offers mechanical durability and thermal conduction while the low weight facilitates rack-mounted and dense-port deployments. The transceiver follows MSA standards for form factor and optical interface, simplifying integration with existing optical hardware. Built-in support for diagnostic monitoring (where supported by host hardware) enables remote observation of supply voltage, optical power and temperature parameters.

Suitable for

Key specifications

How to use

Install the transceiver into a compatible SFP+ port following the host device manufacturer’s instructions and ensure the device is powered down or consult hot-swap guidelines. Connect an LC duplex single-mode fiber patch cord to the transceiver’s ports, observing Tx/Rx orientation. Verify link status using the host equipment’s interface and, if available, read diagnostic values provided by the DDM/DOM feature to confirm correct optical power levels, supply voltage and temperature. When removing the module, disconnect the fiber and use protective caps to prevent contamination of the optical interfaces.

Recommendations

Use high-quality single-mode LC duplex patch cords and clean connector endfaces before mating. Confirm that the host hardware supports SFP+ modules and, if you intend to use DDM/DOM monitoring, verify that the host firmware exposes diagnostic data. Avoid excessive bending of fiber cables and operate the transceiver within the specified ambient temperature and voltage ranges for reliable long-term performance.