SFP+ transceivermodule BlueOptics TN-SFP-10G-U-40-BO 10000 Mbit/s 1270 nm

The BlueOptics TN-SFP-10G-U-40-BO is an SFP+ fiber optic transceiver module designed for 10 Gbit/s data links. It supports single-mode fiber transmission and operates with a nominal wavelength of 1270 nm for one direction of the link. The module follows MSA SFP+ form-factor standards, has an LC simplex optical interface and a compact silver housing with a lightweight design of approximately 20 g, making it suitable for installation in compatible switches, routers and storage systems that accept SFP+ pluggable modules.

Advantages

This BlueOptics SFP+ module provides a standardized, hot-pluggable solution for 10G optical connections with support for single-mode fiber and an LC simplex connector. The module is CE certified and engineered to meet common MSA mechanical and electrical specifications for SFP+ transceivers, enabling straightforward replacement or expansion of existing optical ports. Its compact, lightweight metal housing facilitates installation in high-density networking equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics TN-SFP-10G-U-40-BO by inserting the SFP+ module into a compatible SFP+ slot on your switch, router or storage device until it latches. Connect an LC simplex single-mode patch cable between this transceiver and the corresponding transceiver at the opposite end of the link, ensuring correct transmit/receive pairing. Confirm that the host device firmware or software supports third-party SFP+ modules and, if required, enable any diagnostics or port configuration. Power up the connected devices and verify link status and negotiated speed through the host management interface.

Recommendations

Use single-mode LC simplex fiber patch cords and proper polarity to achieve optimal range and signal quality. Verify that the target hardware supports SFP+ modules and any digital diagnostic monitoring features you require. For long-term reliability, avoid excessive bending of fiber cables and follow ESD handling precautions when installing the transceiver.