SFP-transceivermodule BlueOptics USFP-GB/S1-D-R-BO 1250 Mbit/s 1310 nm

The BlueOptics USFP-GB/S1-D-R-BO is an SFP transceiver module designed for single-mode fiber optic networks. It supports a maximum data transfer rate of 1250 Mbit/s and operates at a wavelength of 1310 nm. The module uses an LC duplex fiber connector, weighs approximately 20 g and is finished in silver. With a maximum transfer distance of up to 20,000 m, this SFP module is suitable for long-reach Gigabit Ethernet links and systems that accept MSA-compliant SFP form factors.

Advantages

The module delivers stable optical transmission at 1310 nm and supports 1.25 Gigabit Ethernet interfaces for reliable data transfer. Its compact SFP form factor is compatible with a wide range of networking hardware that supports MSA-compliant transceivers. The lightweight silver housing facilitates easy installation and hot-plugging in switches, routers and media converters while minimizing space and power footprint.

Suitable for

Key specifications

How to use

Insert the SFP transceiver into a compatible SFP slot on your switch, router or media converter while the host device is powered according to the vendor’s hot-plugging guidelines. Connect single-mode fiber patch cords to the LC duplex connector, observing correct Tx/Rx orientation. Verify link status LED indicators on the host device and confirm negotiated speed and link integrity through the device management interface. If available and supported by the host, enable Digital Diagnostics Monitoring (DDM/DOM) to observe real-time parameters such as optical power and temperature.

Recommendations

Use single-mode LC duplex patch cords and adhere to bend-radius and cleanliness best practices for fiber connectors. Confirm that the target hardware supports MSA-compliant SFP modules and the required 1.25 Gbps protocol. For long-term reliability, keep connectors clean, avoid excessive mechanical stress, and ensure compatible optical budgets when designing links up to 20 km.