SFP-transceivermodule BlueOptics WG8585-BO glasvezel 550 m aluminium

The BlueOptics WG8585-BO SFP transceiver module is a compact fiber optic 1000Base-SX solution designed for multimode fiber links up to 550 meters. Constructed with an aluminium housing and weighing approximately 20 g, the module provides a small form-factor pluggable (SFP) interface with LC duplex connector in compliance with MSA standards. It integrates an 850 nm transmitter and receiver to support reliable optical data transmission at up to 1.25 Gbps for Ethernet, Fibre Channel over Ethernet or SDH/SONET applications.

Advantages

The aluminium enclosure offers durability and effective heat dissipation while the lightweight SFP form factor enables simple hot-plug installation in compatible network equipment. Conformance to MSA standards ensures interoperability with major hardware platforms that support the original WatchGuard WG8585 1000Base-SX module. The transceiver is designed for long service life and stable optical performance over multimode fiber links, and it supports Digital Diagnostics Monitoring (DDM/DOM) when the host device enables that feature.

Suitable for

Key specifications

How to use

Install the BlueOptics WG8585-BO by inserting the SFP module into a compatible SFP slot of your switch, router or storage device until it latches. Connect LC duplex multimode fiber patch cords to the module and the remote transceiver, observing transmit/receive orientation. Ensure the connected hardware supports 1000Base-SX and, if you require digital diagnostics values, verify that the host device supports DDM/DOM. After insertion, confirm link status and correct speed in the host device management interface.

Recommendations

Use high-quality multimode fiber patch cords and properly rated connectors to achieve the specified 550 m range. Avoid bending fiber beyond the recommended radius, keep connector end-faces clean, and confirm that the host device firmware supports third-party SFP modules and DDM/DOM if remote diagnostics are required.