SFP28-transceivermodule BlueOptics MMA2P00-AS-SP-BO 25000 Mbit/s 850 nm

The BlueOptics MMA2P00-AS-SP-BO is an SFP28 transceiver module designed for 25GBASE-SR optical links. It supports a maximum data transfer rate of 25000 Mbit/s over multimode fiber at an 850 nm wavelength and uses an LC duplex connector in a compact SFP28 form factor. With a rated mean time between failures (MTBF) of 3,000,000 hours and a lightweight metal housing of approximately 20 g, the module is intended for long-term deployment in switches, routers and storage systems that accept SFP28 optics.

Advantages

The module provides 25 Gbit/s short-reach performance using multimode fiber and an industry-standard LC duplex interface. Integrated digital diagnostics (DDM/DOM) enable real-time monitoring of optical power, temperature and supply parameters when supported by the host device. Built to MSA form-factor and signaling specifications, the transceiver is compatible with a wide range of hardware platforms that support 25GBASE-SR SFP28 optics. Its compact SFP28 design and low weight simplify installation and hot-swap maintenance.

Suitable for

Key specifications

How to use

Install the SFP28 transceiver into an available SFP28-compliant port on the host device until it latches. Connect LC duplex multimode fiber patch cables with matching polarity to the module’s LC connectors. Ensure the host hardware and firmware support 25GBASE-SR optics and, if required, enable or verify DDM/DOM support to access diagnostic data. Observe standard ESD precautions and avoid contaminating connector endfaces; clean connectors before mating to protect optical performance.

Recommendations

Use OM3 or OM4 multimode fiber for reliable links up to the specified 100 m range, and verify compatibility with the network equipment vendor if the host enforces vendor locking. Regularly monitor DDM parameters when available to detect signal degradation early and schedule maintenance based on measured optical power and temperature trends.