SFP28-transceivermodule BlueOptics XS+31LC10D-BO 25000 Mbit/s 1310 nm

The BlueOptics XS+31LC10D-BO is an SFP28 fiber optic transceiver module designed for high-speed single-mode links. It supports a maximum data rate of 25,000 Mbit/s and operates at a wavelength of 1310 nm. The module uses an LC duplex connector and is housed in a compact silver casing weighing approximately 20 g, suitable for installation in SFP28 ports that accept MSA-compliant modules.

Advantages

This SFP28 module provides 25G transmission over single-mode fiber with 1310 nm optics, enabling long-reach links where low latency and high throughput are required. It is built to industry MSA dimensions for broad compatibility with equipment that supports SFP28 form-factor transceivers. The lightweight metal housing and LC duplex interface simplify handling and installation while maintaining mechanical stability. The module includes support for digital diagnostics monitoring (DDM/DOM) where supported by the host device, allowing remote readout of operating parameters.

Suitable for

Key specifications

How to use

Install the BlueOptics XS+31LC10D-BO into an available SFP28 port on a compatible switch, router or server following the host equipment manufacturer's instructions for hot-plugging transceivers. Connect an appropriate single-mode LC duplex patch cord between transceivers or to a patch panel. Verify the link status in the host device and, if available, enable or read DDM/DOM information to monitor supply voltage, temperature and optical power parameters. Ensure the host device firmware or software supports non-proprietary SFP28 modules for proper recognition and operation.

Recommendations

Use single-mode LC duplex fiber and quality patch cords rated for 1310 nm operation. Verify compatibility with the target hardware and, when possible, test the module in the intended equipment to confirm link stability. Keep transceiver connectors clean and capped when not in use to maintain optical performance.