Coaxkabel S/CONN 80095-G-128CP 5 m F-type wit

The ShiverPeaks Coaxial Cable S/CONN 80095-G-128CP is a 5 m coaxial lead with F-type connectors on both ends, designed to provide stable RF signal transmission for television, satellite and broadband equipment. The cable features a white outer jacket that fits discreetly into home and office environments while offering mechanical durability for everyday installations. Its construction supports common consumer and professional applications where a reliable coax connection is required.

Advantages

This 5-meter coaxial cable delivers consistent signal transfer with minimal loss across short to medium runs, and the standardized F-type terminations ensure compatibility with most satellite receivers, set-top boxes and cable modems. The white outer jacket resists abrasion and keeps the installation visually unobtrusive. The cable's build focuses on long-term mechanical stability and repeated connection cycles without degrading contact quality.

Suitable for

• Connecting satellite receivers to dish or LNB
• Linking cable TV set-top boxes and televisions
• Wiring cable modems and internet gateways
• Temporary and permanent indoor coax installations

Key specifications

• Cable length: 5 meters
• Connector type: F-type on both ends
• Outer jacket color: White
• Application: RF signal transmission for TV, satellite and broadband
• Construction: Shielded coaxial design suitable for indoor use

How to use

Connect one F-type connector to the output of your source device (satellite receiver, cable modem or set-top box) and the other connector to the input on the destination device (television, modem or wall outlet). Ensure connectors are firmly threaded by hand to avoid cross-threading and maintain good electrical contact. Route the cable to avoid tight bends and sharp kinks; support the run with clips or cable ties where needed to prevent strain on the connectors.

Recommendations

For optimal performance, keep cable runs as short as practical and avoid routing alongside power cables to reduce potential interference. When terminating the cable into wall plates or splitters, ensure connectors are fully tightened and, if used outdoors or in damp areas, protect connector joints with appropriate weatherproofing materials. Periodically inspect connectors for corrosion or damage and replace the cable if shielding is compromised.