Steeksleutel Gedore 6577430 Gewicht 1,69 kg Verpakkingsdiepte 130 mm

The Gedore 6577430 open end wrench is manufactured according to DIN 894 and ISO 3318 standards with a jaw set at a 15° angle. Made from Gedore vanadium steel (31CrV3), it is available in sizes from 10 mm up to 135 mm and includes a hanging hole. Smaller sizes up to 38 mm receive a manganese‑phosphate finish; sizes 41 mm and larger are finished steel‑grey. The tool is supplied as a single open end wrench, weight 1.69 kg, package depth 130 mm and height 19 mm.

Advantages

The tool is produced from high‑strength vanadium steel for improved wear resistance and torque transmission. Standardised geometry (DIN 894, ISO 3318) and a 15° jaw angle increase access in confined spaces. The finishing treatment provides corrosion protection appropriate to the wrench size. The hanging hole allows convenient storage.

Suitable for

Key specifications

How to use

Select the wrench size that matches the nut or bolt head. Position the jaws fully over the flat faces of the fastener to avoid slippage and apply steady torque in the required direction. Use the 15° jaw offset to reposition the wrench in tight or awkward spaces. Inspect the wrench before use for damage or excessive wear and replace if necessary.

Recommendations

Do not use the open end wrench on rounded, damaged or non‑hexagonal fasteners; avoid applying impact loads. Store the wrench dry and hang by the hole to reduce corrosion and maintain tool condition.