Voeding DeepCool PL750D WH — 750 W, ATX 20+4-pin, 80 PLUS Bronze, 120mm-ventilator, wit

DeepCool PL750D WH is a non-modular desktop power supply that delivers 750 W of continuous power for standard and gaming PC builds. The unit provides a 20+4 pin ATX main connector, universal AC input supporting 100–240 V at 50/60 Hz, and 80 PLUS Bronze efficiency (approximately 85%). Active cooling is provided by a 120 mm fan and the housing comes in a white finish. The supply is compliant with common international safety and environmental standards and is intended for integration into compatible ATX chassis.

Advantages

The power supply combines a 750 W power output with 80 PLUS Bronze efficiency to balance performance and energy use in mid- to high-power systems. Its 20+4 pin ATX connector ensures compatibility with a wide range of motherboards while the 120 mm fan provides active cooling without occupying excessive space. The white exterior allows for consistent visual integration in cases with white or light-themed builds. Built-in protections and compliance with safety standards reduce installation and operation risks.

Suitable for

• Mid-range to high-performance desktop PCs
• Systems requiring a reliable 750 W supply for multiple components
• White or light-themed PC builds where exterior colour matters
• Basic gaming rigs and content-creation machines without fully modular cabling needs

Key specifications

• Total power: 750 W
• Efficiency rating: 80 PLUS Bronze (approx. 85% efficiency)
• Mainboard connector: 20+4 pin ATX
• Input voltage/frequency: 100–240 V AC, 50/60 Hz
• Cooling: 120 mm fan for active thermal management
• Form factor: standard ATX power supply (non-modular)
• Exterior colour: white

How to use

Install the DeepCool PL750D WH into a compatible ATX chassis following the case manufacturer’s instructions, securing the PSU with the provided screws. Connect the 20+4 pin ATX connector to the motherboard main power socket and attach other required peripheral connectors according to your system layout. Ensure the AC mains cable is rated for your region and plug it into a grounded outlet. Verify airflow inside the case is not obstructed to allow the 120 mm fan to maintain optimal cooling during operation. Perform initial power-on and BIOS checks to confirm stable voltages and system boot.

Recommendations

For stable operation, pair this 750 W non-modular supply with motherboards and components that match its connector layout and airflow requirements. Maintain clear airflow paths and avoid tightly bundled cables near the intake area of the 120 mm fan. If you plan frequent hardware upgrades or need cleaner cable management, consider using extension cables or choosing a modular unit in future builds. Regularly check for dust accumulation on the fan and vents and clean with compressed air while the system is powered off.