Voorpolijstborstel Dremel roestvrijstalen borstel 19 mm (530)

The Dremel Stainless Steel Brush 19 mm (530) is a pre-polishing brush designed for preparing metal surfaces before final polishing. With a 19 mm working diameter and a maximum speed of 15,000 RPM, this stainless steel brush cleans and evens surfaces on metals such as stainless steel, aluminum and pewter without leaving residue that causes "after rust" on corrosion-resistant materials.

Advantages

This 19 mm Dremel stainless steel brush provides consistent pre-polishing performance and is suitable for detailed work due to its compact diameter. The stainless steel filaments are formulated to minimize discoloration and avoid "after rust" on corrosion-resistant metals while effectively removing light oxidation, scale and surface contaminants to improve adhesion for subsequent polishing or finishing steps.

Suitable for

• Preparing stainless steel surfaces for polishing
• Removing light oxidation and scale from aluminum and pewter
• Surface preparation before applying polish or protective coatings
• Detail metalwork and small-area pre-polishing tasks

Key specifications

• Brand: Dremel
• Model / MPN: 26150530JA (530)
• Working diameter: 19 mm (1.9 cm)
• Maximum speed: 15,000 RPM
• Material: Stainless steel filaments
• EAN: 8710364070367

How to use

Attach the brush to a compatible Dremel rotary tool following the tool manufacturer's instructions. Run the rotary tool at speeds up to 15,000 RPM depending on the material and task. Apply light to moderate pressure, moving the brush evenly across the surface to remove oxidation and contaminants. Avoid excessive pressure or prolonged contact in one spot to prevent overheating or damage to thin materials. After pre-polishing, proceed with suitable polishing compounds or finishing steps.

Recommendations

Use appropriate personal protective equipment such as safety glasses and gloves. Test the brush on a small inconspicuous area first to verify the effect on the specific metal. For best results, select a rotational speed and pressure appropriate to the workpiece and follow Dremel tool guidance.