Werkgeheugenmodule Samsung DDR4 8GB 2400 MHz 288-pins DIMM CL17 1,2 V

Samsung 8GB DDR4-2400 memory module in a single 8 GB UDIMM format. Designed for desktop PCs and compatible servers that accept non-ECC 288-pin DIMM modules, this module operates at 2400 MHz with a CAS latency of 17 and a standard DDR4 voltage of 1.2 V. It provides a straightforward capacity upgrade or replacement for systems that support DDR4-2400 memory.

Advantages

The module offers a reliable OEM component from Samsung with standard DDR4 performance at 2400 MHz and low operating voltage. Its single 8 GB stick format simplifies installation and upgrade in systems with available DIMM slots while maintaining industry-standard timings and compatibility with motherboards that support DDR4 UDIMM memory.

Suitable for

• Upgrading desktop PCs to 8 GB of RAM
• Replacing a faulty DIMM in compatible motherboards
• Small office or home workstations requiring standard DDR4-2400 memory

When it may not be suitable

This non-ECC UDIMM is not suitable for systems that require ECC memory (common in many servers and workstation platforms). It also may not be appropriate for laptops or devices that use SO-DIMM modules or different pin counts. Systems that only support higher or lower memory frequencies may not achieve optimal performance with a 2400 MHz module.

Key specifications

• Capacity: 8 GB
• Memory type: DDR4
• Speed: 2400 MHz
• Form factor: 288-pin DIMM (UDIMM)
• CAS latency: CL17
• Operating voltage: 1.2 V

How to use

Power off the computer and disconnect it from the mains. Open the case according to the manufacturer’s instructions, locate an empty 288-pin DIMM slot or remove the existing module if replacing, align the module notch with the slot key and press firmly until the retaining clips click into place. Reassemble the case, reconnect power and boot the system; check BIOS/UEFI to confirm the module is detected and running at the correct frequency and timings.

What to consider before purchase

• Confirm motherboard compatibility with DDR4 2400 MHz UDIMM modules and 288-pin DIMM slots
• Check whether your system requires ECC memory or supports non-ECC UDIMM only
• Verify maximum supported RAM capacity per slot and overall system limits

Recommendations

For balanced performance, install this 8 GB Samsung DDR4-2400 module alongside identical modules (same capacity, speed and timings) when populating multiple DIMM slots; ensure BIOS settings reflect XMP or JEDEC profiles if applicable.