XFP-transceivemodule BlueOptics XFPKT-LR-BO 10000 Mbit/s 1310 nm

The BlueOptics XFPKT-LR-BO is an XFP fiber optic transceiver module designed for 10 Gbit/s (10000 Mbit/s) data transmission over single-mode fiber at a wavelength of 1310 nm. Housed in a compact, silver enclosure and weighing approximately 20 g, this module provides a long-range optical link with LC duplex connectivity in equipment that supports XFP interfaces and the 10GBASE-LR transmission profile.

Advantages

The module supports a high data transfer rate of 10000 Mbit/s and operates at 1310 nm to enable long-distance single-mode fiber links. It follows XFP interface conventions for broad compatibility with networking equipment that accepts XFP transceivers. Its lightweight metal housing and standardized form factor simplify installation and replacement in switches, routers and other compatible hardware. The product is engineered for stable optical performance and straightforward integration into existing fiber networks.

Suitable for

Key specifications

How to use

Install the BlueOptics XFPKT-LR-BO into an XFP-compatible slot on network equipment while the device is powered down or following the vendor's hot-swap guidance. Connect LC duplex single-mode fiber patch cords to the transmitter and receiver ports, observing correct polarity. Ensure the host device is configured for 10GBASE-LR operation and that link settings match the remote endpoint. Verify link status on the host and monitor optical levels if available through the host management interface or the module's diagnostic functions.

Recommendations

Use single-mode, low-loss LC duplex patch cords and, where possible, a patch panel to preserve connector cleanliness and minimize insertion loss. Confirm that the target hardware supports XFP transceivers and 10GBASE-LR operation. If available, enable digital diagnostics (DDM/DOM) on the host to monitor supply voltage, laser bias, transmit/receive optical power and temperature for early detection of link degradation.