XFP transceivermodule BlueOptics 10G-XFP-LR-EN-BO 10000 Mbit/s

The BlueOptics 10G-XFP-LR-EN-BO is a 10 Gigabit XFP transceiver module designed for fiber optic links. Supporting a maximum data transfer rate of 10000 Mbit/s, this silver-coloured module fits XFP interfaces and is compatible with Extreme Networks equipment. Built to industry safety and environmental standards, it meets CE, FCC and RoHS requirements and is specified with a long mean time between failures to support reliable operation in networking environments.

Advantages

This XFP transceiver combines industry-standard connectivity with a compact form factor and low weight for straightforward installation. It offers 10 Gbit/s performance over fiber, broad vendor compatibility with Extreme Networks switches and routers, and compliance with CE, FCC and RoHS standards for safety and environmental conformity. The module’s high mean time between failures contributes to reduced downtime and consistent link availability.

Suitable for

• 10 Gigabit fiber uplinks between switches and aggregation points
• Long‑reach fiber connections in enterprise campus and data center links
• Replacement or upgrade of XFP ports in compatible network equipment
• Environments requiring standards-compliant optical transceivers

Key specifications

• Interface type: XFP
• Maximum data transfer rate: 10000 Mbit/s (10 Gbit/s)
• Product colour: Silver
• Typical weight: 0.02 kg
• Standards: CE, FCC, RoHS compliance
• Reliability: mean time between failures approx. 1,000,000 hours

How to use

Install the module into a compatible XFP slot on the network device while the device is powered off or following the vendor’s hot‑swap instructions. Ensure the optical transceiver is oriented correctly and fully seated until it latches. Connect the appropriate single‑mode or multimode fiber patch cable to the transceiver’s optical port, observing correct transmit/receive pairings. After physical installation, verify link status and configure the device’s port settings as required for 10 Gbit/s operation in the management interface.

Recommendations

Handle the transceiver using ESD precautions, keep dust caps on unused ports, and confirm compatibility with the host device’s firmware and optics policy. For best optical performance, use clean connectors and appropriate fiber type and connectors rated for long‑reach 10G operation.