DIMM 16 GB DDR5-6400, werkgeheugen wit, AX5U6400C3216G-SLABWH, XPG Lancer Blade, INTEL XMP, AMD EXPO

ADATA XPG Lancer Blade 16 GB (1 x 16 GB) DDR5 6400 MHz 288-pin DIMM is a desktop memory module designed to improve system responsiveness and enable high-performance multitasking. This single-module kit provides 16 GB of DDR5 capacity running at 6400 MHz with CAS latency 39, in a 288-pin DIMM form factor compatible with DDR5-capable motherboards. The module incorporates on-die ECC, a low-profile heatsink, and built-in power management features to deliver stable operation in compact builds and standard ATX systems.

Advantages

The Lancer Blade combines high frequency and modern DDR5 features to reduce latency and improve load times for applications and games. Its low-profile heatsink is designed to fit in small cases and to avoid conflicts with large tower CPU coolers, while geometric styling provides a clean aesthetic. Built-in PMIC and on-die ECC enhance power stability and real-time error correction, and support for AMD EXPO and Intel XMP 3.0 simplifies platform-level compatibility and overclocking configuration.

Suitable for

• Desktop PC upgrades where a single 16 GB DDR5 module is needed
• Systems used for multitasking, content creation, and gaming
• Small form-factor builds that require low-profile memory modules
• Platforms that support AMD EXPO or Intel XMP 3.0 for easy overclocking

Key specifications

• Capacity: 16 GB (single module, 1 x 16 GB)
• Memory type: DDR5
• Speed: 6400 MHz
• CAS latency: 39
• Form factor: 288-pin DIMM
• Low-profile heatsink design suitable for compact cases
• On-die ECC for real-time error correction
• Built-in Power Management IC (PMIC) for stable power delivery
• Support for AMD EXPO and Intel XMP 3.0 profiles
• Weight: 0.0362 kg

How to use

Install the module into an available DDR5-compatible DIMM slot on a desktop motherboard following the motherboard manufacturer’s instructions. Ensure the system is powered off and unplugged before installation, align the module with the slot notch, and press evenly until the retaining clips secure it. After powering on, verify the module is detected in the system BIOS/UEFI and enable the desired memory profile (AMD EXPO or Intel XMP 3.0) if you want to use the rated 6400 MHz speed and optimized timings.

Recommendations

Use this module in motherboards with official DDR5 support and updated BIOS/UEFI firmware. For dual-channel or multi-channel configurations, install matched modules in the recommended slots. When enabling overclocking profiles, monitor system stability and temperatures; revert to default settings if instability occurs.