AOC-kabel BlueOptics AOC-QSFP28-CABLE-30M-BO 30 m QSFP28 stekker/stekker

The BlueOptics AOC-QSFP28-CABLE-30M-BO is a 30 metre active optical cable with QSFP28 connectors on both ends, designed for high-speed data transmission in modern networking environments. The cable supports reliable short-reach links between switches, servers and storage devices where low latency and high throughput are required. Constructed for durability and consistent optical performance, this AOC delivers a compact alternative to transceiver-based links while simplifying cabling in dense rack deployments.

Advantages

This active optical cable offers high bandwidth and low latency suitable for 100G QSFP28 ports, with integrated optics that eliminate the need for separate transceivers. The fixed-length 30 m design reduces the number of connection points and potential failure sources while supporting signal integrity over longer short-reach distances than copper. The QSFP28 male-to-male interface provides broad interoperability with equipment that accepts QSFP28 AOC connections. The lightweight, flexible cable jacket and enhanced connector strain relief simplify routing in racks and cable trays.

Suitable for

• Interconnects between 100G QSFP28 switches and servers in data centres
• Connections within high-performance computing clusters
• Links between storage arrays and top-of-rack switches
• Short-reach backbone connections in hyperscale and enterprise networks

Key specifications

• Length: 30 metres
• Connector type: QSFP28 male to QSFP28 male
• Cable type: Active optical cable (AOC)
• Nominal data rate: Designed for 100 Gbit/s class QSFP28 links
• Jacket: Flexible optical cable jacket suitable for rack routing
• Typical use: Short-reach interconnects in data centre and HPC environments

How to use

Install the cable by aligning and inserting the QSFP28 connectors into the corresponding QSFP28 ports on your network devices. Ensure both ends are fully seated and the connector latches (if present) engage to secure the connection. Route the cable to avoid sharp bends and excessive tension; maintain the minimum bend radius specified by the manufacturer to preserve optical performance. No external transceivers are required—devices will recognize the integrated optics when the ports support AOC connections.

Recommendations

Verify port compatibility and firmware support on switches and servers before deployment. Use proper cable management to prevent strain on connectors and avoid tight bends near the connector ends. For critical installations, test link speed and link stability after installation and monitor for any errors during initial operation.