CBO AOC SFP+ SFP-AOC-10G-7M 10G actieve optische kabel 7 m

The CBO AOC SFP+ SFP-AOC-10G-7M 10G Active Optical Cable 7 m is a pre-terminated SFP+ direct-attach solution for 10 Gigabit Ethernet links. This 7-metre active optical cable integrates transceiver functions into the cable assembly to deliver plug-and-play 10Gbps connectivity between switches, servers and storage systems without the need for separate optical transceivers or patch cords. The design targets dense data centre and rack-to-rack interconnects where low latency, reduced power consumption and simplified cable management are important.

Advantages

The cable provides native 10Gbps throughput with low latency and minimal signal loss over 7 metres. Integration of optics into the assembly eliminates the need for separate SFP+ modules and fibre patching, reducing component count and simplifying installation. The AOC construction offers lower power draw compared with discrete transceivers and fibre patch panels, and its compact SFP+ connectors support high-density port layouts. The pre-terminated, polarity-correct assembly reduces the chance of connection errors and shortens deployment time.

Suitable for

• High-speed switch-to-switch links within the same rack or across adjacent racks
• Server-to-switch connections in data centres and server rooms
• Storage array connectivity requiring stable 10Gbps links
• Environments where power efficiency and compact cabling are needed

Key specifications

• Interface: SFP+ direct-attach active optical cable
• Data rate: 10 Gigabit Ethernet (10Gbps)
• Length: 7 metres
• Connector type: SFP+ (bi-directional, hot-pluggable)
• Transmission medium: Active optical fibre within the cable assembly
• Latency: low, suitable for latency-sensitive applications
• Power consumption: lower than equivalent discrete transceiver solutions
• Form factor: compact, suitable for high-density port panels

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ port on the networking equipment until the latch engages. Ensure equipment ports support 10Gbps SFP+ AOC modules and that link negotiation is configured according to the switch or server vendor guidance. No separate transceivers or fibre patching is required. Monitor link status through the device management interface to confirm established 10Gbps operation. For removal, depress the connector latch and withdraw the module carefully to avoid strain on the cable or ports.

Recommendations

Route the cable to avoid sharp bends and mechanical strain; maintain the manufacturer’s minimum bend radius. Use cable management within racks to prevent snagging and to keep airflow unobstructed. Verify compatibility with the host devices’ SFP+ ports and firmware, and update device firmware if required to ensure full functionality. Store and handle the cable by the connector housings when plugging and unplugging to extend service life.