DAC-kabel CBO QSFP28-DAC-2M 2 m compatibel met Nokia QSFP28-poorten

Direct Attach Copper (DAC) cable CBO QSFP28-DAC-2M is a 2-meter passive copper interconnect compatible with Nokia QSFP28 ports. It is engineered for short-range 100GbE links between switches, routers and servers, delivering a fixed, low-latency physical connection for QSFP28 interfaces in data center top-of-rack, aggregation and server environments. The cable supports the electrical signaling and form factor requirements of QSFP28 ports, enabling straightforward deployment without the need for separate transceivers.

Advantages

This 2 m passive DAC cable provides predictable performance for short-reach 100GbE connections, with low power consumption since no active optics or separate transceivers are required. Its direct-attach design reduces component count and simplifies cabling between compatible QSFP28 ports while offering low latency and stable link characteristics. The cable is designed to meet mechanical and electrical requirements of QSFP28 interfaces, ensuring reliable mating and signal integrity for typical data center topologies.

Suitable for

• Short-range 100GbE connections between QSFP28-equipped switches
• Server to switch links in top-of-rack deployments
• Aggregation and spine-leaf links within data center racks
• Temporary or permanent high-speed interconnects where low latency and fixed cabling are preferred

Key specifications

• Length: 2 meters
• Interface: QSFP28 electrical connector on both ends
• Data rate: designed for 100 Gigabit Ethernet (100GbE)
• Cable type: passive copper direct attach
• Typical use range: short-reach, within same rack or adjacent racks
• Power: passive (no additional power required for the cable itself)

How to use

Ensure both devices have compatible QSFP28 ports and that the link speed and configuration support direct attach copper cables. With devices powered off or following hot-plug guidelines from the equipment vendor, align the QSFP28 connectors and insert the cable until the latch engages. Configure the network interfaces according to your switch or server documentation, verify link status in the management interface, and test throughput and error counters to confirm proper operation. For removal, disengage the latch and withdraw the connector following vendor procedures.

Recommendations

Install the DAC cable in environments within recommended temperature and airflow limits of your networking equipment, keep cable bends above the minimum bend radius to preserve signal integrity, and avoid routing next to high-power electrical sources to reduce potential interference. Use this 2 m passive DAC for short, fixed links where low latency and minimal power draw are priorities.