DAC-kabel CBO QSFP28-DAC-3M 3 m compatibel met IBM QSFP28 Direct Attach-koper

CBO QSFP28-DAC-3M is a 3-meter direct-attach copper (DAC) cable compatible with IBM QSFP28 ports. It delivers a low-latency, high-bandwidth connection for short-reach links in data centers and rack environments without requiring separate transceiver modules. The cable preserves the QSFP28 electrical interface and supports straightforward server-to-switch and switch-to-switch interconnects while reducing power consumption and hardware complexity.

Advantages

The DAC cable offers a cost-effective alternative to optical modules for short-distance connections, combining plug-and-play installation with reduced heat and power draw. Its fixed 3 m length minimizes signal loss over short reaches and eliminates the need to manage separate transceivers. Compatibility with QSFP28 ports ensures interoperability with equipment that supports the QSFP28 electrical form factor, allowing reliable 100Gbps-class links when used inside supported systems.

Suitable for

• Short-reach 100GbE links inside racks and between adjacent racks
• Server-to-switch interconnects in data center topologies
• Switch-to-switch uplinks in aggregation and spine-leaf architectures
• Environments where power efficiency and low latency are priorities

Key specifications

• Connector type: QSFP28 compatible direct-attach copper
• Cable length: 3 meters
• Media: copper twinax for short-reach interconnects
• Optimized for low latency and reduced power consumption compared to optical transceivers
• Designed for use with QSFP28 electrical interfaces at 100Gbps-class links

How to use

Insert each QSFP28 connector into the corresponding QSFP28 port on the devices to be interconnected, ensuring the latch engages and the connectors are fully seated. No additional transceiver modules, fiber cabling, or external power are required. Verify link status through the equipment management interface and confirm that both endpoints are configured for the intended speed and link settings. For safe removal, follow the host device’s recommended hot‑swap or power‑down procedures if applicable, then depress the latch and withdraw the connector.

Recommendations

Use this 3 m DAC cable for short-distance connections within and between adjacent racks. Avoid bending the cable beyond its minimum bend radius, route it to prevent mechanical strain on the connectors, and operate within the equipment’s specified temperature range. Confirm compatibility with your switches and servers’ QSFP28 ports and firmware to ensure proper negotiation of link speed and features.