BlueOptics EX-SFP-10GE-ER netwerktransceivermodule glasvezel 10000 Mbit/s SFP+ 1550 nm

The BlueOptics EX-SFP-10GE-ER is a fiber optic SFP+ transceiver module engineered for high-speed data transmission up to 10,000 Mbit/s over single-mode fiber at a wavelength of 1550 nm. Designed for use in network switches, routers and optical transport equipment, this compact module supports extended reach links and is suitable for long-distance communications where signal integrity and low latency are required.

Advantages

The transceiver offers a compact SFP+ form factor that simplifies installation and replacement in compatible ports. Operating at 1550 nm, it enables extended reach compared with shorter-wavelength modules while maintaining a 10 Gbit/s data rate. The module is compatible with a wide range of networking equipment that accepts SFP+ optics, providing predictable performance for point-to-point links and optical uplinks.

Suitable for

Key specifications

How to use

Install the BlueOptics EX-SFP-10GE-ER into an available SFP+ slot on a compatible network device while the device is powered down or following the manufacturer's hot-swap procedure. Connect single-mode fiber patch cables to the transceiver's optical interface, ensuring proper connector type and polarity. Configure the host device's networking settings as required for 10 Gbit/s operation and verify link status through the device management interface.

Recommendations

Use single-mode fiber and compliance-tested patch cables for best performance; verify compatibility with the host device and consult equipment documentation for recommended optics settings and supported link distances.