Netwerktransceivermodule CBO AA1403001-E5 10 Gbit/s XFP 1310 nm

CBO AA1403001-E5 is a BlueOptics XFP network transceiver module designed for 10 Gbit/s fiber-optic links operating at a 1310 nm wavelength. Intended for use in compatible switches, routers and optical line equipment that accept XFP form-factor modules, this transceiver supports high-speed Ethernet and telecom transport over single-mode fiber. The module is hot-pluggable and engineered to provide stable optical performance for long-distance connections where a 10 Gbit/s data rate and 1310 nm wavelength are required.

Advantages

The transceiver combines a standardized XFP form factor with BlueOptics optical components to ensure interoperability with equipment that supports XFP modules. Its 10 Gbit/s data rate and 1310 nm wavelength are suitable for long-reach single-mode fiber links, offering consistent signal quality and low-latency transmission. Hot-pluggable operation simplifies installation and maintenance without powering down host devices, while integrated diagnostics enable monitoring of optical parameters when supported by the host system.

Suitable for

• 10 Gigabit Ethernet links over single-mode fiber
• WAN or metro telecom connections requiring 1310 nm optics
• Edge and core switches, routers and optical transport equipment with XFP slots
• Hot-swap upgrades and field replacements in data centers and carrier networks

Key specifications

• Data rate: 10 Gbit/s
• Optical wavelength: 1310 nm
• Form factor: XFP
• Fiber type: single-mode fiber (SMF)
• Connector type: LC duplex (typical for XFP transceivers)
• Operation: hot-pluggable

How to use

Insert the module into an available XFP slot on a compatible switch, router or optical line system in accordance with the host equipment manual. Ensure correct orientation and secure seating until the module latches. Connect single-mode fiber cables with appropriate LC duplex connectors and verify link status through the host device’s port indicators or management interface. Allow the device to negotiate link parameters automatically; monitor optical levels and diagnostic information if the host supports transceiver monitoring functions.

Recommendations

For reliable long-distance performance, use single-mode fiber with proper end-face cleaning and verify that the host equipment supports XFP modules at 10 Gbit/s and 1310 nm. Avoid bending fiber beyond its minimum bend radius and protect transceiver contacts from dust when not in use.