BlueOptics SFP-10G-BX-D-20-DL-BO netwerk-transceivermodule 10000 Mbit/s SFP+

The BlueOptics SFP-10G-BX-D-20-DL-BO network transceiver module is a single-port SFP+ fiber optic module engineered for 10 Gbit/s connectivity. Housed in a sturdy metal casing and weighing approximately 20 g, this module supports a maximum data transfer rate of 10000 Mbit/s and is suitable for use in switches, routers and other network equipment with SFP+ slots. It is manufactured to meet RoHS and FCC compliance standards and is intended for deployments that require compact, hot-pluggable optical interfaces for high-speed point-to-point links.

Advantages

The metal housing provides mechanical durability and aids heat dissipation for stable operation under continuous load. Support for the SFP+ interface ensures compatibility with a wide range of 10G-ready networking devices. The compact, lightweight design simplifies installation and enables dense port deployments while the hot-pluggable form factor allows maintenance or upgrades without powering down the host equipment.

Suitable for

Key specifications

How to use

Install the BlueOptics SFP-10G-BX-D-20-DL-BO by inserting it into an available SFP+ slot on compatible network equipment until it clicks into place. Connect the appropriate single-mode or multimode fiber cable to the transceiver's optical interface following the host device documentation. The module supports hot-plug operation, but verify any device-specific requirements for link negotiation or firmware configuration. Monitor link status through the host system to confirm successful negotiation at 10 Gbit/s.

Recommendations

Use certified fiber cables and keep connector end-faces clean to ensure optimal optical performance. Verify compatibility with the host device vendor for supported transceiver models and link parameters. Install in environments within the equipment’s specified operating temperature and humidity ranges and avoid physical stress or contamination of the module and cable connectors.